Expert Answers about Tiffin Allegro Bus Motorhome

• Brake Controller Wiring on Motorhome
• To answer your first question about installing the Prodigy P3 # 90195 I recommend going with 10 gauge wire # 10-1-1 over that distance. As for your other question, you can zip tie your wires to the underside of the coach but you are going to want to use Heat Shrink Butt Connectors # DW05745-10 at your connection points to seal your ground and hot lead wires and protect them from dirt, water and the like; also be sure you have a proper ground on both your coach and trailer.
  view full answer...


• Does Prodigy P3 Brake Controller Plug into 2013 Tiffin Allegro With Powerglide Chassis
• To install the Tekonsha Prodigy P3 Trailer Brake Controller # 90195 on your 2013 Tiffin Allegro Bus you will need to hardwire it in as there is not a port that allows it to plug in. We have previously confirmed with Tiffin that there will be four wires under your driver's side dash that have butt conectors on them, and you will use these to wire in the Prodigy brake controller. The wires from the Prodigy are going to be Black for power, Blue for brake controller output, Red for stop light...
  view full answer...


• How Does Brake Controller Install in 2014 Tiffin Allegro Bus on Powerglide Chassis
• Yes, the brake controller install method you referenced for the 2018 2018 Tiffin Phaeton would be the same as your 2014 Tiffin Allegro bus with Powerglide Chassis. Under your driver side dash there are 4 wires that have butt connectors on them. They are labeled as to which wire is for which function.To install your Tekonsha Prodigy P3 # 90195 on your Phaeton simply connect the following wires from the pigtail that comes with the P3 to the following functions: Black - 12V Power Supply White...
  view full answer...


• Winterizing Fogotti Tankless Water Heater
• To winterize your Fogatti tankless water heater you basically drain all of the fluid out and blow the lines out with compressed air. Unplug the water heater Shut off and disconnect the water supply and outlet to the heater Used compressed air to blow out all fluid in the lines.
  view full answer...


• Does the Brake Output Wire Need to be Ran with the Tekonsha Prodigy RF Wireless Brake Controller
• You are correct about the Tekonsha Prodigy RF Wireless Trailer Brake Controller part # TK94FR in that all you will need is 12 volt power on the 7-way. Unfortunately, there is not easy way to go back and forth between a 4-way and 7-way trailer connector on the trailer side at least. However, you can go back and forth between a 4-way and 7-way trailer connector on the vehicle side and for that I recommend the Adapter 4-Pole to 7-Pole and 4-Pole part # 37185. The only thing you will need...
  view full answer...


• What Is the Replacement Lens for Gustafson 3" Recessed RV Puck Light Made Of And How Does It Install
• The Replacement Lens for Gustafson 3" Recessed RV Puck Light part # 277-000393 is made of plastic, not glass and it features a press-in installation.
  view full answer...